MSP678 | GAC 4.86 in. 123mm Thread Length / Military-Style Connector without Mating Half Connector / Stainless

10VDC (From Speed Control) / Variable Speed - Off-Road

12VDC / Packard Connector without Mating Connector / Mitsubishi L-Series L2E, L3E & S-Series S3L, S3L2, S4L, S4L2

24VDC / Packard Connector with Mating Connector EC1300 / Cold Start Solenoid / Install Kit KT291 Included

3.45 in. [88mm] Thread Length / 3 in. [76mm] Harness / Automotive Connector / Same as MSP6724 with Mating Harness CH1206 / Aluminum Gold Anodized

24VDC / Universal - Caterpillar & Cummins / 4-20mA or 0-5VDC Load Sharing Input / 100% Max Duty Cycle Output

24VDC / Right Side Stop Assembly / Installation Kit (Gasket, Bolts) Included

175 Series Installation Kit - For Zexel RS/RSV Governor / Right Hand Rack / Mounts Actuator Directly to Intermediary Mechanical Governor Housing - Adapter Plate, Linkage, Gaskets (Governor Housing and Actuator), Hardware

Multi-VDC / Two Oxygen Sensor Inputs (Pre and Post Catalyst) and EGT (Type-K Thermocouple) Input

2.29 in. [58mm] Thread Length / 9 in. [228mm] Harness / Metri-Pack 150 Series (Unsealed) without Mating Connector EC1518 / Aluminum

AFR Series - 8 ft. [2.4m] Harness / Flying Leads / 35-Wires

12VDC / Male Push-On Terminals / Isuzu L-Series 3LB1, 3LD1, 3LD2, 4LE1, 4LE2

12VDC / Terminal Strip

24VDC / Packard Connector without Mating Connector

24VDC / Interface Module Scania S6 (EMS) EFI SY to GAC LSM/SYC / Nominal 5VDC Input / 1.6VDC Output

3 in. [76mm] Thread Length / Military-Style Connector without Mating Half Connector / Stainless

12V / ADC225S with Integrated EDG6000 / Requires EC1502 or CH1520 (Not Included)

ACB, ADB, ATB-T4 Military-Style (Amphenol) Actuators - 12 ft. [3.6m] Harness / Straight Connector EC1000 / 6-Terminal

EDG6000 - Programming Interface Assembly with Serial Port

ADC (Commercial) Actuators - 7 ft. [2.13m] Harness / 2-Terminal

EDG6000 Series - 8 ft. [2.4m] Harness / Flying Leads / 14-Wires

1 Turn / 20KΩ / With Knob / Droop Control

12VDC / 6.5 lbf. [3.0 kg] / 0.25 ft-lb [0.34 J] Work / Male Push-On Terminals

24VDC / 13.0 lbf. [6.0 kg] / 0.50 ft-lb [0.68 J] Work / Male Push-On Terminals

SDG Series - Deutsch Mating Connector Kit / SDG514 & 524 / 12-Terminal

Multi-VDC / Standard Unit

Multi-VDC / Light-Force (Low-Current Optimized PID) / For Cummins EFC Forward Acting (Normally Closed)

12VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203

1.7 in. [43mm] Thread Length / 6 ft. [1.8m] Shielded Cable / Flying Leads / Stainless

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203

10 Turn / 20KΩ / With Knob

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Greater Rate Return Spring SP207

Multi-VDC / Switchable Soft Coupling and Lead Circuit

275 Installation Kit - MTU - Bosch P 3000 Bearing Retainer Kit - Plate, Gasket, Seal, Shims, Hardware

Multi-VDC / Built-In Display / Terminal Strip - SUPERCEDED BY EEG6500, SERVICE ONLY

Multi-VDC / Standard Unit

MSP / Engine Speed Simulator, Alligator Clips, General Usage