MSP6741 | GAC 2.29 in. 58mm Thread Length / 9 in. 228mm Harness / Metri-Pack 150 Series (Unsealed) without Mating Connector EC1518 / Aluminum

EDG6000 - Programming Interface Assembly with Serial Port

EDG6000 Series - Mating Connector Kit / 14-Terminal

EDG6000 Series - 8 ft. [2.4m] Harness / Flying Leads / 14-Wires

12VDC / Packard Connector without Mating Connector / Install Kit KT291 Included

Multi-VDC / For Cummins EFC Reverse-Acting (Normally Open)

110 Series - Mating Connector Kit / 2-Terminal

24VDC / Light-Force (Low-Current Optimized PID)

2.37 in. [60mm] Thread Length / 1 ft. [0.3m] Harness / Flying Leads / Aluminum Clear Anodized

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203

12VDC / Deutsch Connector without Mating Connector / Same as ACD110A

Multi-VDC / Light-Force (Low-Current Optimized PID) / Anti-Windup Circuit (Gaseous) / Recommended for T1/T2 ATBs

24VDC / Interface Module Scania S6 (EMS) EFI SY to GAC LSM/SYC / Nominal 5VDC Input / 1.6VDC Output

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203 / Thin Rubber Stop 26 Degrees Travel

SDG Series - Programming Harness for SDG514 & 524 with Serial Port

CE-Compliant / 24VDC / Isochronous Load Sharing / Load Anticipation / Droop / Forward and Reverse Power Monitoring and Reset Capability / Power Monitor Adjustment Control / Generator Power Ramping and Control

3.19 in. [81mm] Thread Length / 2.75 in. [70mm] Harness / Automotive Connector / Stainless

1.7 in. [43mm] Thread Length / 6 ft. [1.8m] Shielded Cable / Same as MSP6730 except with Packard Connector without Mating Connector / Stainless

176 Series Installation Kit - For Bosch RS/RSV Governor / Left-Hand Rack / Mounts Actuator Directly to Intermediary Mechanical Governor Housing - Adapter Plate, Linkage, Gasket, Hardware

Multi-VDC / Two Element Speed Switch - Overspeed, Crank

24VDC / Barber Colman Dyna 2 Load Sharing (80100, 80101, 80104, 80105) to GAC ESD

Multi-VDC / Military-Style Connector without Mating Connector / Sand-Cast Housing

24VDC / 6.5 lbf. [3.0 kg] / 0.25 ft-lb [0.34 J] Work / Male Push-On Terminals

MSP Automotive Sensors - 4 ft. [1.2m] Unshielded Cable / 2-Terminal

5 in. [127mm] Thread Length / Military-Style Connector without Mating Half Connector / Stainless

Installation Bracket - ALN050 Starter Plate (Rectangular with Holes Pre-Drilled for Mounting Actuator)

295 Installation Kit - Spare (Included with Actuator) - Rack Linkages, Hardware

MSP Military-Style (Amphenol) Sensors - 10 ft. [3m] Shielded Harness / Straight Connector EC1100 / 2-Terminal

1/4 in. I.D. End and 1/4-28 UNF-2B Thread 0.719 in. Deep

ACB, ADB, T4 (Military-Style) Actuators - Mating Connector Kit / Straight / 6-Terminal

24VDC / Packard Connector with Mating Connector EC1300 / Cold Start Solenoid / Install Kit KT291 Included

ADD (Packard) Actuators - Connector Kit Replacement / 2-Terminal

Multi-VDC / Military-Style Connector without Mating Connector / Stop Lever LE1400-4 Included

3.13 in. [79mm] Thread Length / 3 in. [76mm] Harness / Automotive Connector / Stainless

24VDC / Terminal Strip [Compatible with ESD5330/5340 and NEW EEG6500 Series]

12VDC / Packard Connector with Mating Connector EC1300 / Lesser Rate Return Spring SP203

24VDC / Military-Style Connector without Mating Connector / Specially Designed for MTU / Stop Lever LE1400-4 Included