ADD176A-12 | GAC 12VDC / Packard Connector without Mating Connector / Install Kit KT291 Included

Multi-VDC / Perkins 1306-E87 7M351 to GAC LSM/SYC

24VDC / Full-Fuel Starting Aid

3.5 in. [89mm] Thread Length / #8-32NC-2A Thread Stud Terminals / High Output 1.2kΩ / Aluminum

EDG6000 Series - 8 ft. [2.4m] Harness / Flying Leads / 14-Wires

175 Series Installation Kit - Bosch A Pump / Right Hand Rack - Includes Adapter Plate, Bearing Retainer (KT176A), Spring, Gaskets, Linkage, Hardware

1.7 in. [43mm] Thread Length / 6 ft. [1.8m] Shielded Cable / Same as MSP6730 except with Packard Connector without Mating Connector / Stainless

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203

12VDC / Packard Connector without Mating Connector / Shibaura (Perkins) N843-C, N844L-C, N844LT-C (Caterpillar C-series or Volvo D2, contact GAC)

12VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203 / Thin Rubber Stop 26 Degrees Travel

MSP6741 - Mating Connector Kit / 2-Terminal / Metri-Pack 150 Series (Unsealed)

4.86 in. [123mm] Thread Length / Military-Style Connector without Mating Half Connector / Stainless

Multi-VDC / Three Element Speed Switch - Overspeed, Crank, Parallel

Multi-VDC / Military-Style Connector without Mating Connector / Sand-Cast Housing

5 in. [127mm] Thread Length / 12in. [305mm] Harness / Flying Leads / Stainless

10 Turn / 5KΩ / With Locking Shaft

12VDC / Packard Connector with Mating Connector EC1300 / Lesser Rate Return Spring SP203

24VDC / Commercial Connector with Mating Harness CH251-2134 7 ft. [2.13m] / Lesser Rate Return Spring SP203 / Thin Rubber Stop 26 Degrees Travel

10VDC (From Speed Control) / Variable Speed - Off-Road

Installation Bracket - 225 Series to Woodward Dyna 8000 Footprint (Raised Base so Shafts Line-Up)

EDG6000 Series - Mating Connector Kit / 14-Terminal

24VDC / Packard Connector with Mating Connector Kit EC1300 / With Installation Kit KT292 (O-Ring, Bolts)

JDR Series - Mating Connector Kit / 6-Terminal

275 Installation Kit - RP21 Series - Adapter Plate, Link, Hardware

12VDC / Right Side Stop Assembly / Installation Kit (Gasket, Bolts) Included

24VDC / Standard Unit

Multi-VDC / For Cummins EFC Reverse Acting or Fire Pump Applications / Expanded Frequency Range 10.5kHz

Multi-VDC / Built-In Display / Terminal Strip - SUPERCEDED BY EEG6500, SERVICE ONLY

ACB, ADB, ATB-T4 Military-Style (Amphenol) Actuators - 12 ft. [3.6m] Harness / 90° Connector EC1010 / 6-Terminal

Multi-VDC / MTU M-DEC to GAC LSM/SYC

24VDC / Volvo EMS I & II EFI Control (2.875V Nominal Input) to GAC LSM/SYC

10 Turn / 5KΩ / With Knob

MSP Military-Style (Amphenol) Sensors - 27 ft. [8.2m] Shielded Harness / Straight Connector EC1100 / 2-Terminal

4.3 in. [110mm] - Actuator Control Lever - 1/4 in. [6.35mm] Holes / Serrated Shaft

3.19 in. [81mm] Thread Length / 2.75 in. [70mm] Harness / Automotive Connector / Stainless

5 in. [127mm] Thread Length / Military-Style Connector without Mating Half Connector / Stainless

24VDC / Packard Connector without Mating Connector / Heavy Duty Bearing Retention / Position Feedback Sensor / Stop Lever LE1400-4 Included